New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Hi All

Many thanks for all the in put from every one, I'm gonna make a start towards the end of this month, I've just ordered the Pen Turners bible off Amazon, I'm very much a visual learner so if I can see it I can generally understand it.
InkFingers
Why do you use a metal lathe in particular rather than just a small table top lathe?

[QUOTE="kjmc1957, post: 131684, member: 213"] Hi All Many thanks for all the in put from every one, I'm gonna make a start towards the end of this month, I've just ordered the Pen Turners bible off Amazon, I'm very much a visual learner so if I can see it I can generally understand it. InkFingers Why do you use a metal lathe in particular rather than just a small table top lathe? [/QUOTE]

Verification