New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Inkyfingers,
Is that the standard BSP taps and dies you are using ?
I was thinking of using them as they are quite a fine thread, the 1/8th BSP is about 3/8" dia and has 28 TPI, and the 1/4 BSP is about 1/2" and has 19 TPI.
I should have some of those sitting in a toolbox somewhere

[QUOTE="donwatson, post: 131800, member: 503"] Inkyfingers, Is that the standard BSP taps and dies you are using ? I was thinking of using them as they are quite a fine thread, the 1/8th BSP is about 3/8" dia and has 28 TPI, and the 1/4 BSP is about 1/2" and has 19 TPI. I should have some of those sitting in a toolbox somewhere :nooidea: [/QUOTE]

Verification