• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Cut them on a bandsaw a fraction over then sand by putting a drum sander in a drill press. I did some this way the only picture of a very similar set up that I can find is when I wanted some small stock for a car model I made.


.


The bumpers where made this way




As you can see from the model there are a few bits that needed to be sanded in this way.



Top