• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Thanks David,


Surely if the blade is the problem then one fence or two, unless they match the angle of the drift the blade will cut through the workpiece at the wrong angle?


I must be misunderstanding it.


Anyway, here's the bottom rollers.  Might be able to invert the mounts to move them closer perhaps:


Top