New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Yep that's all I did but used a roller bearing cos I hadn't seen it done before and needed a means to an end.
It helped me keep the wood flowing through nice and straight for a one handed operation, worked well at the time.
I still have it somewhere in the event I need to use it again I would just spend 3 or 4 days looking for it, quicker to make another init?

[QUOTE="Grump, post: 180140, member: 232"] Yep that's all I did but used a roller bearing cos I hadn't seen it done before and needed a means to an end. It helped me keep the wood flowing through nice and straight for a one handed operation, worked well at the time. I still have it somewhere in the event I need to use it again I would just spend 3 or 4 days looking for it, quicker to make another init? [/QUOTE]

Verification