New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Melanie in these days of adapters the chuck compatability seems to be much better between lathes. I have tried always to keep away from No 1 Morse Taper so from lathe to lathe then is much easier, my belief is the increased strength in the larger taper is for me essential.

Peter.

[QUOTE="Penpal, post: 287005, member: 122"] Melanie in these days of adapters the chuck compatability seems to be much better between lathes. I have tried always to keep away from No 1 Morse Taper so from lathe to lathe then is much easier, my belief is the increased strength in the larger taper is for me essential. Peter. [/QUOTE]

Verification