New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Just to clarify, the problem I have is with the posting end bush. The part you turn down to is off centre by a few thousandths of an inch which translates into a slightly amount more material on one side of the finial and flush on the other when the pen was assembled. I'm sure it's just an odd one and Dan is sending me another so it's all good.

[QUOTE="rayf6604, post: 99728, member: 482"] Just to clarify, the problem I have is with the posting end bush. The part you turn down to is off centre by a few thousandths of an inch which translates into a slightly amount more material on one side of the finial and flush on the other when the pen was assembled. I'm sure it's just an odd one and Dan is sending me another so it's all good. [/QUOTE]

Verification