• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

What tolerance did you give the eingnering company as you might find if you did not give them one it will be to 0.1 mm which when It comes to a fit is no good I would say you should be at around 0.05 mm tolerance at the max



Sent from my iPad using Tapatalk


Top