New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I did something similar to this but not having a metal lathe I turned a Morse taper out of some scrap, epoxied some corian on the end and reinforced with some hot glue (which you can turn with a skew by the way when hard). I attach some roughly cut out sticky backed sanding disks to it and it works a treat!

[ATTACH]620[/ATTACH]

[QUOTE="naxie, post: 7316, member: 105"] I did something similar to this but not having a metal lathe I turned a Morse taper out of some scrap, epoxied some corian on the end and reinforced with some hot glue (which you can turn with a skew by the way when hard). I attach some roughly cut out sticky backed sanding disks to it and it works a treat! :thumbs: [ATTACH]620._xfImport[/ATTACH] [/QUOTE]

Verification