New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

If it is tripping the breaker on a ring main which are probably rated at 30 amps then something is definitely wrong it is pulling too much current somewhere or tripping the RCD circuit. It maybe that some wires are loose internally on the Lathe I would take it back and ask for a replacement.

[QUOTE="bigbob, post: 224161, member: 699"] If it is tripping the breaker on a ring main which are probably rated at 30 amps then something is definitely wrong it is pulling too much current somewhere or tripping the RCD circuit. It maybe that some wires are loose internally on the Lathe I would take it back and ask for a replacement. [/QUOTE]

Verification