• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Thanks Bob


I went with the 11mm drill bit and drilled slowly on the lathe... When test inserting the tube it wasn't particular ill loose and I used thick CA liberally applied to the heavily roughed tube and it stuck very firmly in the blank, very quickly.


I haven't looked into Gorrila glue as yet.. But will do..


Thanks for the tip!


Top