New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Hi, Chris, Welcome to the forum, matey!

Those pens are very good for your debut attempts. As the members have said, this is all part of the learning curve and you'll soon get past those little glitches. One tip with the shrinkage problem - is the gap wide enough to roll a rubber "O" ring into? If so then roll away!

Bob.

[QUOTE="bluntchisel, post: 227185, member: 249"] Hi, Chris, Welcome to the forum, matey! Those pens are very good for your debut attempts. As the members have said, this is all part of the learning curve and you'll soon get past those little glitches. One tip with the shrinkage problem - is the gap wide enough to roll a rubber "O" ring into? If so then roll away! Bob. [/QUOTE]

Verification