New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Merry Christmas!

Have you considered switching to carbide? Wide square rods don't need much left hand involvement and register very well against the toolrest. No risk of catches if your RH control is good. Always good presentation of the cutter to the surface. Hardly any skill involved ;)

[QUOTE="mChavez, post: 372652, member: 5119"] Merry Christmas! Have you considered switching to carbide? Wide square rods don't need much left hand involvement and register very well against the toolrest. No risk of catches if your RH control is good. Always good presentation of the cutter to the surface. Hardly any skill involved ;) [/QUOTE]

Verification