• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Find a decent engineer local to you, should be loads where you are (used to be at least a few years ago)


They should be able to do the bearings for a LOT less than that.  Even a decent mechanich should be able to do it, similar principle to wheelbearings after all.


HTH


Top