New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I have checked all the ones I have Paul and some of the barrel ends (posting end, not nib end) can be pushed in by hand (some could be pulled back out again by hand but some needed a tap with a punch) but all the other fittings are a good fit. I would not say they were a loose fit but the tolerance is not as tight as the other components. (on the ones I have)

[QUOTE="Walter, post: 111493, member: 95"] I have checked all the ones I have Paul and some of the barrel ends (posting end, not nib end) can be pushed in by hand (some could be pulled back out again by hand but some needed a tap with a punch) but all the other fittings are a good fit. I would not say they were a loose fit but the tolerance is not as tight as the other components. (on the ones I have) [/QUOTE]

Verification