• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Oh well must be just me then. I drilled a couple more after I did this post and the tolerance was okay. My drills say 15/32 on them so not a metric equivalent as far as I can tell.


Top