Macaronytony
Graduate Member
Hi does anybody know the thread size on the Omega section to body?
I know the pitch is 0.75, just a bit unsure about the size...
I know the pitch is 0.75, just a bit unsure about the size...
-
Thanks for visiting The Penturners Forum today.
There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.
To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.
Omega section to body?
- Thread starter Macaronytony
- Start date
wm460
Grand Master
- Joined
- Mar 16, 2013
- Posts
- 23,128
- First Name
- Mark
Dan would be the bloke to ask, I believe he has some experience with pens..
Dan's tied up moving boxes in to his new overhead. I believe it is 8.3
Macaronytony
Graduate Member
Thanks Phil for the info...
Any idea where i can get this Die?Want to make a few sections to take the rollerball feeds your getting..
Ha - Don't start!!! One tap at a time - my bank manager doesn't have a sense of humour.Thanks Phil for the info...
Want to make a few sections to take the rollerball feeds your getting..
You might find it easier to chase out the inside of the existing housing with the 6.5 x0.5 taps, but that's theoretical advice at the moment - I haven't yet got them. They're somewhere over the Atlantic.
Macaronytony
Graduate Member
Thanks again Phil. Have read the same thing elsewhere. I will wait for Dan to finish the move then pester him for some spares... :-)