New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Barry, instead of making the hole bigger so that the straw goes all the way through you could use a smaller diameter tube that goes through the vinamold and into the straw, I use an empty cross style refill take the wriring tip off, flush it with acetetone to get the ink residue out and cut it in half, use each half for each side. Just make sure no vinamold block the end of the tubes.

Peter

[QUOTE="Buckeye, post: 145372, member: 294"] Barry, instead of making the hole bigger so that the straw goes all the way through you could use a smaller diameter tube that goes through the vinamold and into the straw, I use an empty cross style refill take the wriring tip off, flush it with acetetone to get the ink residue out and cut it in half, use each half for each side. Just make sure no vinamold block the end of the tubes. Peter [/QUOTE]

Verification