New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I saw this on a YouTube video and thought it was quite neat.

https://www.pennstateind.com/store/PKSQUARE.html

I don't have any angle but I do have some alloy bar so I knocked this up today. Just a 3" X 2" X 11/2" block tapped M6 and three mandrels. 6mm, 8mm and 10mm so far.

To use it I'll just clamp it to the mitre fence on my disc sander like the Penn state one.

[QUOTE="21William, post: 233963, member: 1324"] I saw this on a YouTube video and thought it was quite neat. [url]https://www.pennstateind.com/store/PKSQUARE.html[/url] I don't have any angle but I do have some alloy bar so I knocked this up today. Just a 3" X 2" X 11/2" block tapped M6 and three mandrels. 6mm, 8mm and 10mm so far. To use it I'll just clamp it to the mitre fence on my disc sander like the Penn state one. [IMG]http://i230.photobucket.com/albums/ee286/Arbalist/image_zpsgftwmnhw.jpeg[/IMG] [/QUOTE]

Verification