New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Nope, a I did this one whilst waiting for a load of people to turn up for a meeting regarding the workshop project the base was an old template for something cant remember what. The risers chop off from each end of the blank as I say just a sizing and idea session it works in a clumsy way but not good enough needs to be more delicate and less obvious. Also shows the need to "polish" the cuts in the plastic hot air gun works well hence the laser cut comment do it once and be done!! Tomorrow its a back to pens cutlery handles and write ups might also do some work on the engraving machine I need to learn some programming tweaks chassis built but like a ferrari with no engine

[QUOTE="trapper, post: 6080, member: 64"] Nope, a I did this one whilst waiting for a load of people to turn up for a meeting regarding the workshop project the base was an old template for something cant remember what. The risers chop off from each end of the blank as I say just a sizing and idea session it works in a clumsy way but not good enough needs to be more delicate and less obvious. Also shows the need to "polish" the cuts in the plastic hot air gun works well hence the laser cut comment do it once and be done!! Tomorrow its a back to pens cutlery handles and write ups might also do some work on the engraving machine I need to learn some programming tweaks chassis built but like a ferrari with no engine:rolling: [/QUOTE]

Verification