New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I made one using the bearing and M2 from a live centre I turned the end for over the mandrel out of very hard wood glued a washer on the end to stop damage from the bushings and drilled it to the right size. It works fine and didn't cost the 27 pound which would be about $90 here.

[QUOTE="Ian, post: 20798, member: 98"] I made one using the bearing and M2 from a live centre I turned the end for over the mandrel out of very hard wood glued a washer on the end to stop damage from the bushings and drilled it to the right size. It works fine and didn't cost the 27 pound which would be about $90 here. [/QUOTE]

Verification