New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

As promised, here's a picture of the perspex pen stand I've been making. The component parts can be seen in the inset. The only real problem is that the perspex was an old piece I'd had in the garage and it's protective polythene was missing and there were a few good scratches. I've not glued it up yet so might texture the surface somehow to hide the scratches or even spray it black or white. Then again, I think I've spent enough time on it already!! Now I've got a template though, I could always make one out of wood and just alter the slots to suit.

[ATTACH]4675[/ATTACH]

[QUOTE="Kardav, post: 49397, member: 387"] As promised, here's a picture of the perspex pen stand I've been making. The component parts can be seen in the inset. The only real problem is that the perspex was an old piece I'd had in the garage and it's protective polythene was missing and there were a few good scratches. I've not glued it up yet so might texture the surface somehow to hide the scratches or even spray it black or white. Then again, I think I've spent enough time on it already!! Now I've got a template though, I could always make one out of wood and just alter the slots to suit. [ATTACH]4675._xfImport[/ATTACH] [/QUOTE]

Verification