This next photo shows the return spring & housing fitted also the hub for the handles with the one undamaged handle attached.
Back to the lathe to turn some knobs on the new levers.
Handles refitted along with the motor housing plate & some pimping started
At this point I cleaned up & painted the Meddings badge
I striped the motor, although this wasn't the original one I wanted to see what state it was in, I changed the bearings & cleaned off all the paint.
The belt cover was in a poor state so I decided to give it a couple of coats of black paint just to see if it would look better than in grey, it did so I fixed the badge, did a little more pimping & fitted the cleaned up motor.
