New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

The US seem very good at coming up with new ideas. one I have seen and like is Stainless Steel made bushings. Some are made with no center hole but instead have a 45 degree inverted cone on the back edge for your drive and tail center to go into. Some have a hole and also the inverted cone.

[QUOTE="TaylorsMirfield.co.uk, post: 228105, member: 476"] The US seem very good at coming up with new ideas. one I have seen and like is Stainless Steel made bushings. Some are made with no center hole but instead have a 45 degree inverted cone on the back edge for your drive and tail center to go into. Some have a hole and also the inverted cone. [/QUOTE]

Verification