New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I did not join the forum for English lessons since most contributions make fundamental errors that are meaningless to me what matters is content this subject touches on every member on the forum in the way mandrels , bushes and tubes are made. For ever I have used a go no go guage to measure tubes since this is fundamental and I discard tight tubes only rely on bushes as spacers, mandrels as varying, I match my precision made Mandrel savers to actual in use mandrels. For Dan to tackle a basic essential for penmaking could be a vital step forward for too long near enough has been accepted by manufacturers and some dealers, full marks best wishes Dan.

Peter.

[QUOTE="Penpal, post: 228284, member: 122"] I did not join the forum for English lessons since most contributions make fundamental errors that are meaningless to me what matters is content this subject touches on every member on the forum in the way mandrels , bushes and tubes are made. For ever I have used a go no go guage to measure tubes since this is fundamental and I discard tight tubes only rely on bushes as spacers, mandrels as varying, I match my precision made Mandrel savers to actual in use mandrels. For Dan to tackle a basic essential for penmaking could be a vital step forward for too long near enough has been accepted by manufacturers and some dealers, full marks best wishes Dan. Peter. [/QUOTE]

Verification