• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Good question Gary ...


No, only with additives, but i will leave this until i test the new casting from yesterday which has gone off, but a little damp on top. The temperature is around 6/7°C which maybe a little cold for the PR ... :thinks:


Taking the pot to a chap tomorrow who is going to stop the small leak i have, i know it didn't drop much but i would like it to hold its pressure at least ...


Top