New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

That's ok mate - just wanted to make sure I wasn't being really dense there! Thanks for confirming.

I like the idea of using other centre bands to mix & match etc and vary what sizes suit the bands when turning, but for these 5 the guy just wants them straight and slim at least.
Might get some of those though, thanks for the heads up Peter.

I finally managed to buy a laser module that's suitable for doing engraving so once I get that I need to make/get a suitable heatsink and power supply, then I can lash it on my mill/cnc machine and do laser engraving on wood products. Huzzah!

[QUOTE="MrJoshua, post: 162583, member: 937"] That's ok mate - just wanted to make sure I wasn't being really dense there! Thanks for confirming. I like the idea of using other centre bands to mix & match etc and vary what sizes suit the bands when turning, but for these 5 the guy just wants them straight and slim at least. Might get some of those though, thanks for the heads up Peter. I finally managed to buy a laser module that's suitable for doing engraving so once I get that I need to make/get a suitable heatsink and power supply, then I can lash it on my mill/cnc machine and do laser engraving on wood products. Huzzah! [/QUOTE]

Verification