• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Not sure if this is obvious as well, but you want the length of the tool shaft where it meets the jig to be constant. So I was told to drill 2 inch hole in a block of wood. Stick the tool in and slid jig etc.


Top