New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Checked the lathe again , the motor is now sticking even under no pressure, give it half a turn manually and then it starts, ??
Will give record a ring in the morning, methinks a new motor is needed,
Still got my old blue CL3 that works well,
Been looking at a small DML305 recently , this may make the decision easier to make..

[QUOTE="johnny5, post: 140833, member: 284"] Checked the lathe again , the motor is now sticking even under no pressure, give it half a turn manually and then it starts, ?? Will give record a ring in the morning, methinks a new motor is needed, Still got my old blue CL3 that works well, Been looking at a small DML305 recently , this may make the decision easier to make.. [/QUOTE]

Verification