New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Just thought I'd add this as I was using mine today, these are they

[ATTACH]7494[/ATTACH]

There is a double step in them as they are made to fit in the mitre tracks of both the spindle moulder & bandsaw which are slightly different , this is them holding a finger board pushing some 9" Oak against the bandsaw fence whilst deep ripping.

[ATTACH]7495[/ATTACH]

[QUOTE="Doug, post: 75305, member: 241"] Just thought I'd add this as I was using mine today, these are they [ATTACH]7494._xfImport[/ATTACH] There is a double step in them as they are made to fit in the mitre tracks of both the spindle moulder & bandsaw which are slightly different , this is them holding a finger board pushing some 9" Oak against the bandsaw fence whilst deep ripping. [ATTACH]7495._xfImport[/ATTACH] [/QUOTE]

Verification