New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I don't know the resin so don't know if it is the cause.

It almost looks like the resin was pushed or blasted around the pot. How much pressure are you using and how fast do you put it into the pot? If there is nothing to diffuse the incoming air and it blasts straight down into the molds the resin will blow all around. Resin splatters on the pot walls would point to that. Try applying the air more slowly.

Pete

[QUOTE="Curly, post: 370111, member: 2148"] I don't know the resin so don't know if it is the cause. It almost looks like the resin was pushed or blasted around the pot. How much pressure are you using and how fast do you put it into the pot? If there is nothing to diffuse the incoming air and it blasts straight down into the molds the resin will blow all around. Resin splatters on the pot walls would point to that. Try applying the air more slowly. Pete [/QUOTE]

Verification