New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I too have suffered this and the only cure seems to be to preprint either the barrels , the inside of the drilled hole , or both.
I have concerns about rubbing the paint off if the fit is a bit tight but am assured this is less of an issue than I imagine it to be.
Meanwhile the white blanks are going to be turned back and i’ll reuse the tubes

[QUOTE="howsitwork?, post: 358798, member: 2121"] I too have suffered this and the only cure seems to be to preprint either the barrels , the inside of the drilled hole , or both. I have concerns about rubbing the paint off if the fit is a bit tight but am assured this is less of an issue than I imagine it to be. Meanwhile the white blanks are going to be turned back and i’ll reuse the tubes [/QUOTE]

Verification