New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Thanks for your comments, Lance.
If you have a mitre guage for your bandsaw, all these cuts can be done. You may have a bit more sanding to do, though.
If you can make a sled for the mitre guage that can cut 45 degrees accurately, then segmenting should not be a problem.
Once you can cut 45's then cut 60/30 triangles and you will be flying.

[QUOTE="alan morrison, post: 374136, member: 2049"] Thanks for your comments, Lance. If you have a mitre guage for your bandsaw, all these cuts can be done. You may have a bit more sanding to do, though. If you can make a sled for the mitre guage that can cut 45 degrees accurately, then segmenting should not be a problem. Once you can cut 45's then cut 60/30 triangles and you will be flying. [/QUOTE]

Verification