• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Jim not usually.  I trim the glue squeeze out and veneer that sticks up after each glue up with the utility knife.  I have 4 straight edges, 3/4, 7/8, 15/26, & 1 inch.  I make the strips equal to the blank thickness for little or no waste.  The straight edges are 1/4 inch plexiglass.  After making over 600 serpentine blanks I have the process down pretty good.


Top