• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Bob there may not be many turning on Sherline lathes but if I was I would use the lathe tool post and conventional  steel bits to do the initial turning to the round.


Peter I have Taig lathes of a similar size.:thumbs::thumbs:


Top