New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

This is one of the latest pens I made this week. It is made with juniper wood, segmented with brass and inlaid with coral. Then it was finished with several layers of CA. Curiously the segment was damaged by the drill , so I repair it with new brass and solve the problem adding coral dust with ca . This is the result.....
[ATTACH]17721[/ATTACH]
And it is a particular of the inlay:
[ATTACH]17722[/ATTACH]

[QUOTE="Stefano, post: 173721, member: 799"] This is one of the latest pens I made this week. It is made with juniper wood, segmented with brass and inlaid with coral. Then it was finished with several layers of CA. Curiously the segment was damaged by the drill :sob:, so I repair it with new brass and solve the problem adding coral dust with ca :winking:. This is the result..... [ATTACH=CONFIG]17721._xfImport[/ATTACH] And it is a particular of the inlay: [ATTACH=CONFIG]17722._xfImport[/ATTACH] [/QUOTE]

Verification