Sierra Pen Issue

[mkenny28]

Does anyone else have an issue with a slight "wiggle" on the mechanism part and the end of the blank??

 

[Neil]

Does anyone else have an issue with a slight "wiggle" on the mechanism part and the end of the blank??

Martin,

The Sierra is a much copied pen, sometimes good, sometimes bad. If you are asking for clarity on whether you have an issue with a manufacturing defect we are going to ask from where you got it. The Sierra, as you may well be aware is a snug, but non grip fit at the point you have highlighted and the issue you seem to think might exist is the difference in the id of the tube and the id of the pen at that point - is it to loose? This style of Sierra looks as though it might be from woodturningz or the same supplier they buy from, and from memory they are a bit “looser” than other fits. If others that you have are equally loose and you prefer a tighter fit the easy option would be to source it elsewhere but I doubt whether there is a factory fault causing the issue.

 

[flexi]

As Neil has said above, I have had this before when I have had label cast blanks or other custom blanks cast they may say Sierra but some can be a better fit than others... I now supply the caster with my own tubes

 

[Garno]

Neil has hit the nail on the head so to speak, it is a minefield out there.

The pen looks ok and maybe you could use it as a "house pen"

 

[Penpal]

A position of mistrust shared by all of us.

 

[mkenny28]

oh yes, i have a few "house pens". think i might not be helping the situation running drill bits down the tube to clear away excess epoxy. gonna try the potato trick and keep the inners of my tubes clear when gluing up. thanks for the advice.

 

[wm460]

I use play dough instead of a spud.

 

[CraftyNick]

I tend use blu tack as my wife gets it free from her office.