New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

[URL unfurl="true"]https://www.ukdrills.com/morse-taper-shank/morse-taper-imperial-bit[/URL]

£5.28, but you'll pay P&P. Sometimes cheaper from the same place on Ebay.

I have their set of bits from 6mm to 10mm in 0.1mms which is good - it's often good to go a size under the recommended size.

I tend to stick to the same kits and have MT bits for them.

[QUOTE="Gert Fitcher, post: 359815, member: 2253"] [URL unfurl="true"]https://www.ukdrills.com/morse-taper-shank/morse-taper-imperial-bit[/URL] £5.28, but you'll pay P&P. Sometimes cheaper from the same place on Ebay. I have their set of bits from 6mm to 10mm in 0.1mms which is good - it's often good to go a size under the recommended size. I tend to stick to the same kits and have MT bits for them. [/QUOTE]

Verification