New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

If you're using the correct shaft on the barrel trimmer it won't make any difference however you use it because it will stay straight, guided by the tube but if its slack then you need to ensure it goes in straight so either the lathe, a pillar drill or a very good eye and hand drill.

[QUOTE="paulm, post: 159057, member: 283"] If you're using the correct shaft on the barrel trimmer it won't make any difference however you use it because it will stay straight, guided by the tube but if its slack then you need to ensure it goes in straight so either the lathe, a pillar drill or a very good eye and hand drill. [/QUOTE]

Verification