New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Good pens Bob
I have to Axminster AH-1218VS. It is great for doing pens and bowls of 10" and under. I'm not sure what the thread size is on a Record RPML300 but I'm guessing you would have to change your chuck or get an adaptor and the Morse taper is also a different size on the Axi compared to Record lathes.

[QUOTE="chas_41_uk, post: 112013, member: 441"] Good pens Bob :thumbs: I have to Axminster AH-1218VS. It is great for doing pens and bowls of 10" and under. I'm not sure what the thread size is on a Record RPML300 but I'm guessing you would have to change your chuck or get an adaptor and the Morse taper is also a different size on the Axi compared to Record lathes. [/QUOTE]

Verification