New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Well done Bob I had one of them lathes for a few years with the bowl outboard and it was a fantastic little machine but being a lazy ol git I swapped it for the 305 V/S which is a fantastic machine but at £800 it should be another way round the tailstock problem is to drill a hole through the top of bolt and fix a bar in it then you wont need a spanner happy turning mate

[QUOTE="Woody, post: 112184, member: 192"] Well done Bob I had one of them lathes for a few years with the bowl outboard and it was a fantastic little machine but being a lazy ol git I swapped it for the 305 V/S which is a fantastic machine but at £800 it should be another way round the tailstock problem is to drill a hole through the top of bolt and fix a bar in it then you wont need a spanner happy turning mate [/QUOTE]

Verification