New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Good to hear the end of the tripping problem phantom tripping aside earth leakage may be the way to go but it causes so many probs when it takes out the main breaker before the one on that circuit. I spent a day or two once with this problem it came down to the connections at the switch board were connected in the wrong way for earth leakage on the workshop circuit difficult because it was the neutral wiring fitted by a handyman.

Like your small lathe looks like it is brand new.

Peter.

[QUOTE="Penpal, post: 153082, member: 122"] Good to hear the end of the tripping problem phantom tripping aside earth leakage may be the way to go but it causes so many probs when it takes out the main breaker before the one on that circuit. I spent a day or two once with this problem it came down to the connections at the switch board were connected in the wrong way for earth leakage on the workshop circuit difficult because it was the neutral wiring fitted by a handyman. Like your small lathe looks like it is brand new. Peter.:thumbs: [/QUOTE]

Verification