New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Hi, last night I turned my 4th blank, a yew. When I came to assembly the clip wouldn't fit over the end cap so I filed it out a bit and carried on, this is a slimline. I thought it assembled well but on close inspection the yew has a tiny split right next to the end cap about 4mm long. So the question is did I mess up the assembly or may the end cap have been slightly oversize ?
Regards Terry

[QUOTE="amazilia, post: 27183, member: 164"] Hi, last night I turned my 4th blank, a yew. When I came to assembly the clip wouldn't fit over the end cap so I filed it out a bit and carried on, this is a slimline. I thought it assembled well but on close inspection the yew has a tiny split right next to the end cap about 4mm long. So the question is did I mess up the assembly or may the end cap have been slightly oversize ? Regards Terry [/QUOTE]

Verification