New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

What sticker thing?

As to minimum thickness I have always worked on the principle that if there is at least 1 millimetre of resin above the parts then it's okay, I haven't had any returned. I did come close to ruining one when I turned through the resin to reveal the centre of the hands, you could only tell that I had done that because when I micro-meshed it the centre of the hands was brighter and shinier that the rest of the hands, but I could simple have put a few coats of CA on it and it would have been fine. I kept it to see what happened to the hands, but they are still as bright and shiney as the day it was made.

Peter

[QUOTE="Buckeye, post: 109685, member: 294"] What sticker thing? As to minimum thickness I have always worked on the principle that if there is at least 1 millimetre of resin above the parts then it's okay, I haven't had any returned. I did come close to ruining one when I turned through the resin to reveal the centre of the hands, you could only tell that I had done that because when I micro-meshed it the centre of the hands was brighter and shinier that the rest of the hands, but I could simple have put a few coats of CA on it and it would have been fine. I kept it to see what happened to the hands, but they are still as bright and shiney as the day it was made. Peter [/QUOTE]

Verification