• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

I don't know about reasonably priced but if you can source a pre owned Record (Nova) 1624 lathe complete with outboard rig this will allow bowls of up to 29" in diameter. I recently sold one to Neil and used it for some quite large bowls (15") and never had any trouble with movement.


Ray


Top