New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

To use the lathe safely it really should have a slot in the back of the quill for the tang on the chuck to engage with to stop it spinning I have had a drill chuck start spinning and the drill then whipped round and broke with but going every were I only use it now we're the pillar drill is not got the travel on it to reach

Sent from my iPad using Tapatalk

[QUOTE="bellringer, post: 209009, member: 68"] To use the lathe safely it really should have a slot in the back of the quill for the tang on the chuck to engage with to stop it spinning I have had a drill chuck start spinning and the drill then whipped round and broke with but going every were I only use it now we're the pillar drill is not got the travel on it to reach Sent from my iPad using Tapatalk [/QUOTE]

Verification