New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Easy to make I used to go to Steel Sellers and but shorts and use flat steel cut the stem at 45 degrees, make short and long such a easy task for you or a welder mate be very aware and careful of your stem measurement though a sloppy stem is not your friend nor is a fraction over size an easy trap for the unwary.

Peter.

[QUOTE="Penpal, post: 195701, member: 122"] Easy to make I used to go to Steel Sellers and but shorts and use flat steel cut the stem at 45 degrees, make short and long such a easy task for you or a welder mate be very aware and careful of your stem measurement though a sloppy stem is not your friend nor is a fraction over size an easy trap for the unwary. Peter.:fingers: [/QUOTE]

Verification