• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Traditional Pen Assembly Fault

G

glenpen

Graduate Member
Joined
May 4, 2014
Posts
708
Location
Southport
First Name
Glen
Thanks to everyone who sent a response to my last thread. I checked on my turning and found the cap end was not correct, at each end I had not quite trimmed to the length of the brass tube making the wood 1/16" to long preventing the tip of the pen not entering the plastic. Now everything ok.

Glen:love_it:
 
Vic Perrin

Vic Perrin

Moderator
Executive Member
Joined
Feb 23, 2014
Posts
8,215
Location
Rugeley Staffs
First Name
Vic
Well sorted then. I need to remember this as I have got some of those kits to have a go at when I get a Roundtuit!

:thumbs::thumbs:
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top