New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Triple E is made in Australia by U Beaut who run one of the most complete wood working forums in the world with infinite sub groups the owner makes the pducts in a small factory dedicated to his finishes. I use triple E as the fist cut on plastic blanks after the skew on the flat it is a remarkable product my biggest problem using it is I tend not to put the lid on and forget it dries out this way but normally will have sufficient product to last most casual penmakers for years so whatever the cost in the UK its a very cheap product when
you amortise it as one of your costs it is very small.

Kind regards Peter.

[QUOTE="Penpal, post: 38645, member: 122"] Triple E is made in Australia by U Beaut who run one of the most complete wood working forums in the world with infinite sub groups the owner makes the pducts in a small factory dedicated to his finishes. I use triple E as the fist cut on plastic blanks after the skew on the flat it is a remarkable product my biggest problem using it is I tend not to put the lid on and forget it dries out this way but normally will have sufficient product to last most casual penmakers for years so whatever the cost in the UK its a very cheap product when you amortise it as one of your costs it is very small. Kind regards Peter.:thumbs: [/QUOTE]

Verification