New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Just to let you know, I'm currently in the process of getting a selection of triple lead taps and dies on board for custom makers, because they seem to be more or less impossible to obtain other than from outside the UK

They will be TapCo, the same as the nib taps I've already got, and I've asked them to look at 11 x 0.8, 12 x 0.8 and 13 x 0.75, which I propose to make available as a set, comprising a 1 inch diameter die with a corresponding intermediate tap.

If there are other sizes you think should be there, or that taps should also include starters and/or plugs (bottoming) please let me know so I can consider adding them to the order.

Phil

[QUOTE="Phil Dart, post: 211807, member: 735"] Just to let you know, I'm currently in the process of getting a selection of triple lead taps and dies on board for custom makers, because they seem to be more or less impossible to obtain other than from outside the UK They will be TapCo, the same as the nib taps I've already got, and I've asked them to look at 11 x 0.8, 12 x 0.8 and 13 x 0.75, which I propose to make available as a set, comprising a 1 inch diameter die with a corresponding intermediate tap. If there are other sizes you think should be there, or that taps should also include starters and/or plugs (bottoming) please let me know so I can consider adding them to the order. Phil [/QUOTE]

Verification